Towing 439 |
the cover and pry open the cover. |
After towing, remove the towing hook from the vehicle and stow it in the under-floor storage compartment.
Fit the towing hook cover on the bumper.
|
WARNING |
||||||||
|
1 Towing hook covers( Depending on the vehicle, there may be only one cover.)
2. Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch the bumper. Insert the flathead screwdriver into the cutout of
|
3. Screw the towing hook into the threaded hole until its thread can no longer be seen.
4. Tighten the towing hook securely using the jack handle.
|
. Do not use the towing hook for purposes other than towing your vehicle.
. Be sure to remove the towing hook after towing. Leaving the towing hook mounted on the vehicle could interfere with proper operation of the fuel pump shut off function when the vehicle is struck from behind.
|
CAUTION
. To prevent deformation to the bumper and the towing hook, do not apply an excessive load to the towing hook.
. For models equipped with BSD( Blind Spot Detection) and RCTA( Rear Cross Traffic Alert) driving support systems, when towing another vehicle, touch“ Rear Vehicle Detection( BSD / RCTA)” to deactivate the system. The sys-
|
In Case of Emergency
9
|
||||
– CONTINUED – |