Vehicle Dynamics Control System 339 |
||||
|
vation of this function is indicated by flashing of the Vehicle Dynamics Control operation indicator light.
NOTE
. The Vehicle Dynamics Control system may be considered normal when the following conditions occur. – Slight twitching of the brake pedal is felt. – The vehicle or steering wheel shakes to a small degree.
– An operating noise from the engine compartment is heard briefly when starting the engine and when driving off after starting the engine.
– The brake pedal seems to jolt when driving off after starting the engine.
. In the following circumstances, the vehicle may be less stable than it feels to the driver. The Vehicle Dynamics Control System may therefore operate. Such operation does not indicate a system malfunction. – On gravel-covered or rutted roads – On unfinished roads – When the vehicle is towing a trailer
|
– When the vehicle is fitted with snow tires or winter tires
. Activation of the Vehicle Dynamics Control system will cause operation of the steering wheel to feel slightly different compared to that for normal conditions.
. It is always important to reduce speed when approaching a corner, even if the vehicle is equipped with Vehicle Dynamics Control.
. Always turn off the engine before replacing a tire as failure to do so may render the Vehicle Dynamics Control system unable to operate correctly.
& Vehicle Dynamics Control System Monitor s07an01
Refer to“ Vehicle Dynamics Control Warning Light / Vehicle Dynamics Control Operation Indicator Light” FP167 and“ Vehicle Dynamics Control OFF Indicator Light” FP168.
& To Turn On / Off the Vehicle Dynamics Control System
s07an07
To turn the Vehicle Dynamics Control on and off, operate the center information display. Refer to“ Car settings” FP202( 11.6-inch display models) or“ Vehicle
|
setting icons” FP220( dual 7.0-inch display models).
Creating an adequate driving wheel slip by deactivating the Vehicle Dynamics Control system temporarily may help to escape from the following situations. Turn the Vehicle Dynamics Control system off when necessary.
. A standing start on a steeply sloping road with a snowy, gravel-covered, or otherwise slippery surface
. Extrication of the vehicle when its wheels are stuck in mud or deep snow
|
When turning off the Vehicle Dynamics Control system during engine operation, the Vehicle Dynamics Control OFF indicator light on the combination meter illuminates. The Vehicle Dynamics Control system will be deactivated. When“ Vehicle Dynamics Control” has been touched again to reactivate the Vehicle Dynamics Control system, the Vehicle Dynamics Control OFF indicator light turns off.
You should not deactivate the Vehicle Dynamics Control system except under the above-mentioned situations.
CAUTION
The Vehicle Dynamics Control system helps prevent unstable vehicle motion such as skidding using con-
– CONTINUED –
|
7
Starting and Operating
|