Mirrors 253 |
|||||||
|
! Reprogramming a Single HomeLink ® button s03ap070406
To program a previously trained button, follow these steps:
1. Press and hold the desired HomeLink ® button. DO NOT release the button.
2. The indicator light will begin to slowly flash orange after 20 seconds. The HomeLink ® button can be released at this point. Proceed with“ Programming a New HomeLink ® button”- step 3.
3. If you do not complete the programming of a new device to the button, it will revert to the previously stored programming.
! Garage Door Two-Way Communication s03ap070413
HomeLink ® has the capability of communicating with your garage door opener. HomeLink ® can receive and display“ closing” or“ opening” status messages from compatible garage door opener systems. At any time, HomeLink ® can also recall and display the last recorded status communicated by the garage door opener to indicate your garage door being“ closed” or“ opened”.
HomeLink ® has the capability of receiving this communication from the garage door opener at a range up to 820 feet( 250 m).
|
Range may be reduced by obstacles such as houses or trees. You may have to slow your vehicle speed to successfully receive the garage door opener communication.
! Programming Two-Way Communication s03ap070414
1 Status Indicators
Within 5 seconds after programming a new HomeLink ® button, both of HomeLink’ s garage door status indicators will flash rapidly green indicating that the garage door two-way communication has been enabled. If your garage door status indicators flashed, two-way communication programming is complete.
If the garage door status indicators do not flash, additional HomeLink ® information and programming videos can be found
|
online at www. HomeLink. com and www. youtube. com / HomeLinkGentex. |
! Using Two-Way Communication s03ap070415
1 Status Indicator
Recall and display( at any time) the last recorded garage door status message communicated to HomeLink ® by simultaneously pressing HomeLink ® buttons 1 and 2 for 2 seconds. HomeLink ® will display the last recorded status for 3 seconds.
If two-way communication programming is successful, HomeLink ® will display the status of your garage door opener with arrow indicators( see below).
– CONTINUED –
|
3
Instruments and Controls
|