|
less access function may not operate properly .
. When the access key fob is within the operating range , it is possible for anyone , even someone who is not carrying the access key fob , to operate the keyless access function . Note that the keyless access function can be operated only by the door handle , door lock sensor or rear gate opener button in the operating range in which the access key fob is detected .
. It is not possible to lock the doors , the rear gate and the fuel filler lid using the keyless access function when the access key fob is inside the vehicle . However , depending on the status of the access key fob and the environmental conditions , the access key fob may be locked inside the vehicle . Before locking the vehicle , make sure that you have the access key fob .
. When the battery of the access key fob is discharged , or when operating it in a location with strong radio waves or noise ( e . g ., near a radio tower , power plant , broadcast station or an area where wireless equipment is used ), or while talking on a cell phone , the operating ranges may be reduced , or the keyless
|
access function may not operate . In such a case , perform the procedure described in “ Locking and Unlocking ” FP442 .
. The doors may lock or unlock when the car is being washed or exposed to a significant amount of water that touches the door handle while the key fob is still in the operating range .
! How to lock and unlock s02ap0108
It is possible to perform the following operations when you are carrying the access key fob .
. Lock and unlock the doors and the fuel filler lid .
. Lock and unlock the rear gate .
NOTE
. It is not possible to lock the doors , the rear gate and the fuel filler lid using the keyless access function when the push-button ignition switch is in the “ ACC ” or “ ON ” position . Refer to “ Switching Power Status ” FP149 .
. If the door handle is gripped with a gloved hand , the door lock may not be released .
. If the door lock sensor is touched four times or more repeatedly , the system will ignore the sensor operation
|
.
. When performing the locking procedure too quickly , locking may not complete . After performing the locking procedure , it is recommended to pull the rear door handle to confirm that the doors have been locked .
. If any of the doors ( including the rear gate ) is not fully closed , the following will occur to alert you . – An electronic chirp sounds five times . – The hazard warning flashers flash five times .
. If any of the doors or the rear gate is open , the doors , the rear gate and the fuel filler lid cannot be locked .
. Within 3 seconds after locking the doors and the rear gate using the keyless access function , it is not possible to unlock the doors and / or the rear gate using the keyless access function .
. When locking , be sure to carry the access key fob to prevent locking the access key fob in the vehicle .
. The setting of the hazard warning flasher operation can be changed by operating the center information display . For details , refer to “ Car settings ” FP202 ( 11.6-inch display models ) or “ Vehicle setting icons ”
|
2
Keys and Doors
|
– CONTINUED – |