488
Battery
3 . If the new blade rubber is not provided with two metal spines , remove the metal spines from the old blade rubber and install them in the new blade rubber .
4 . Align the claws of the plastic support with the grooves in the blade rubber assembly , then slide the blade rubber assembly into place .
Securely retain both ends of the rubber with the stoppers on the plastic support ends . If the rubber is not retained properly , the wiper may scratch the rear window glass .
5 . Install the wiper blade assembly to the wiper arm . Make sure that it locks in place .
6 . Hold the wiper arm by hand and slowly lower it in position .
11-20 . Battery
WARNING s11ba
. Before beginning work on or near any battery , be sure to extinguish all cigarettes , matches , and lighters . Never expose a battery to an open flame or electric sparks . Batteries give off a gas which is highly flammable and explosive .
. For safety , in case an explosion does occur , wear eye protection or shield your eyes when working near any battery . Never lean over a battery .
. Do not let battery fluid contact eyes , skin , fabrics , or paint because battery fluid is a corrosive acid . If battery fluid gets on your skin or in your eyes , immediately flush the area with water thoroughly . Seek medical help immediately if acid has entered the eyes .
If battery fluid is accidentally swallowed , immediately drink a large amount of milk or water , and seek medical attention immediately .