442
Rear Gate – If the Rear Gate Cannot Be Opened
5 . When the keyless access with pushbutton start system is deactivated , press the push-button ignition switch with the brake pedal released . The status of the push-button ignition switch then changes to “ ON ”.
NOTE
If the power does not switch even though the above procedure was followed precisely , contact your SUBARU dealer .
& Starting Engine s09ap03
1 . Apply the parking brake .
2 . Place the select lever in the “ P ” position .
3 . Depress the brake pedal .
4 . Hold the access key fob with the buttons facing you , and touch the push-button ignition switch with it . When the communication between the access key fob and the vehicle is completed , a chime ( ding ) will sound . At the same time , the push-button ignition switch turns to the “ ACC ” or “ ON ” position .
5 . After the push-button ignition switch turns to the “ ACC ” or “ ON ” position , while depressing the brake pedal , press the push-button ignition switch .
NOTE
If the engine does not start even though the above procedure was followed precisely , contact your SUBARU dealer .
9-10 . Rear Gate – If the Rear Gate Cannot Be Opened s09ag
In the event that you cannot open the rear gate by pressing the rear gate opener button , you can open it from inside the cargo area .
1 . Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch . Remove the access cover at the bottom-center of the rear gate trim using flat-head screwdriver .