Starting and operating / Preparing to drive 7-9
Preparing to drive
S07AC
You should perform the following checks and adjustments every day before you start driving .
1 . Check that all windows , mirrors , and lights are clean and unobstructed .
2 . Check the appearance and condition of the tires . Also check tires for proper inflation .
3 . Look under the vehicle for any sign of leaks .
4 . Check that no small animals enter the engine compartment .
5 . Check that the hood and rear gate are fully closed .
6 . Check the adjustment of the seat .
7 . Check the adjustment of the inside and outside mirrors .
8 . Fasten your seatbelt . Check that your passengers have fastened their seatbelts .
9 . Check the operation of the warning and indicator lights when the ignition switch is turned to the “ ON ” position .
10 . Check the gauges , indicator and warning lights after starting the engine .
CAUTION
Trapping small animals in the cooling fan and belts of the engine may result in a malfunction . Check that no small animal enters the engine compartment and under the vehicle before starting the engine .
NOTE
. Engine oil , engine coolant , brake fluid , washer fluid and other fluid levels should be checked daily , weekly or at fuel stops . . When towing a trailer , refer to “ Trailer hitch ” F8-16 .
Starting and stopping the engine ( models without pushbutton start system )
CAUTION
S07BD
Do not operate the starter motor continuously for more than 10 seconds . If the engine fails to start after operating the starter for 5 to 10 seconds , wait for 10 seconds or more before trying again .
NOTE
It may be difficult to start the engine when the battery has been disconnected and reconnected ( for maintenance or other purposes ). This difficulty is caused by the electronically controlled throttle ’ s self-diagnosis function . To overcome it , keep the ignition switch in the “ ON ” position for approximately 10 seconds before starting the engine .
– CONTINUED –