Keys and doors / Remote keyless entry system 2-19
& Sounding a panic alarm
S02AQ08
To activate the alarm , press the “ PANIC ” button once .
The horn will sound and the hazard warning flashers will flash .
To deactivate the panic alarm , press any button on the remote transmitter . Unless a button on the remote transmitter is pressed , the alarm will be deactivated after approximately 30 seconds .
& Setting audible signal operation ( models without “ keyless access with push-button start system ”)
S02AQ09
Using an electronic chirp , the system will give you an audible signal when the doors lock and unlock . If desired , you may turn the audible signal off .
Perform the following steps to deactivate the audible signal . You can also use the same steps to restore the function .
1 . Sit in the driver ’ s seat and shut all doors and the rear gate .
2 . Hold down “ ” of the power door locking switch .
3 . While holding down “ ” of the power door locking switch , pull the key out and reinsert it into the ignition switch at least 6 times within 10 seconds after Step 2 .
4 . Open and close the driver ’ s door once within 10 seconds after Step 3 .
5 . The hazard warning flashers flash 3 times to indicate completion of the setting .
Your SUBARU dealer can perform the above procedure for you . Also , for models with a combination meter display ( color LCD ), the setting can be changed using the display . For details , refer to “ Vehicle Setting ” F3-41 .
& Replacing the battery
S02AQ12
Refer to “ Replacing key battery ” F11-45 .
& Replacing lost transmitters
S02AQ13
If you lose a transmitter or want to purchase additional transmitters ( up to four can be programmed ), your transmitters should be reprogrammed for security reasons . For details , contact your SUBARU dealer and have the transmitters programmed into the remote keyless entry system .
& Certification for remote keyless entry system
S02AQ18
! U . S . -spec. models
S02AQ1801
FCC ID : CWTB1G077 FCC ID : CWTD1G141
CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user ’ s authority to operate the equipment .
– CONTINUED –