Instruments and controls / Light control switch 3-67
High beam assist indicator
When the high beam assist function is activated, the high beam assist indicator light on the combination meter will illuminate.
NOTE
If the high beam assist function is malfunctioning or is temporarily stopped, the headlight will be fixed at low beam.
! How to temporarily lower the sensitivity of the high beam assist function
S03AH0704
The sensitivity of the high beam assist function can be lowered by performing the following operations.
1. Before turning the ignition switch to the“ ON” position, set the light control switch to the“ AUTO” position and push the signal lever forward( high beam position).
2. Turn the ignition switch to the“ ON” position and within approximately 15 seconds, press the“ /”( following distance setting) switch more than 10 times consecutively.
When the sensitivity of the high beam assist function is lowered, the EyeSight temporary stop indicator( White)“” on the combination meter will illuminate.
NOTE
. The sensitivity of the high beam assist function cannot be lowered in the following conditions. – Cruise control or Adaptive Cruise Control is in operation – The EyeSight warning indicator( yellow) is illuminated. The sensitivity of the high beam assist function returns to normal level
the next time the ignition switch is turned to the“ LOCK”/“ OFF” position and the engine is restarted.
! How to change the headlight mode manually
S03AH0702
Change to the low beam:
When you return the turn signal lever to the center position, the high beam assist function will turn off and the high beam assist indicator light will turn off.
Change to the high beam:
When you turn the light control switch to the“” position, the headlight mode will be changed to the high beam.
At this time, the high beam assist function will turn off, the high beam assist indicator will turn off and the high beam indicator light will turn on.
NOTE
. After manually changing the headlight mode to the high beam, if you turn on the high beam assist function, return the light control switch to the“ AUTO” position.. When manually changing the headlight mode to the high beam, if you turn the light control switch to the“” position, the instrument panel illumination, parking lights, front side marker lights, rear side marker lights, tail lights
– CONTINUED –