Subaru Crosstrek Manuals 2018 Crosstrek Owner's Manual | Page 212

3-76 Instruments and controls/Wiper and washer & One-touch lane changer To flash the turn signal and turn signal indicator light three times, push the turn signal lever up or down slightly and immediately release it. NOTE The operational/non-operational setting of the one-touch lane changer can be changed by a SUBARU dealer. Contact the nearest SUBARU dealer for details. For models with the combina- tion meter display (color LCD), the setting can also be changed by operat- ing the combination meter display (color LCD). For details, refer to “Vehi- cle Setting” F3-41. Wiper and washer WARNING In freezing weather, do not use the windshield washer until the wind- shield is sufficiently warmed by the defroster. Otherwise the washer fluid can freeze on the windshield, blocking your view. CAUTION . Do not operate the washer con- tinuously for more than 10 sec- onds, or when the washer fluid tank is empty. This may cause overheating of the washer motor. Check the washer fluid level fre- quently, such as at fuel stops. . Do not operate the wipers when the windshield or rear window is dry. This may scratch the glass, damage the blade rubbers and might cause the wiper motor to fail. Before operating the wiper on a dry windshield or rear win- dow, always use the windshield washer. . In freezing weather, be sure that the blade rubbers are not frozen to the windshield or rear window before switching on the wipers. Attempting to operate the wiper with the blades frozen to the window glass could cause not only the blade rubbers to be damaged but also might cause the wiper motor to fail. If the blade rubbers are frozen to the window glass, be sure to operate the defroster, windshield wiper dei- cer (if equipped) or rear window defogger before turning on the wiper. . If the wipers stop during opera- tion because of ice or some other obstruction on the window, this might cause the wiper motor to fail even if the wiper switch is turned o ff. If this occurs, promptly stop the vehicle in a safe place, turn the ignition switch to the “LOCK”/“OFF” po- sition and clean the window glass to allow proper wiper operation. . Use clean water if windshield washer fluid is unavailable. In areas where water freezes in winter, use SUBARU Windshield Washer Fluid or the equivalent.