3-68
Instruments and controls/Light control switch
When exiting:
While the welcome lighting function is
activated, the low beam headlights will
remain illuminated even when either of the
following operation is done.
. The push-button ignition switch is
turned to the “OFF” status (models with
“keyless access with push-button start
system”)
. The key is pulled out from the ignition
switch (models without “keyless access
with push-button start system”)
The low beam headlights will turn off under
any of the following conditions.
. 3 minutes have passed since the low
beam headlights were illuminated by the
welcome lighting function.
. 30 seconds have passed since the door
is opened and closed. *1
. The light control switch is turned to a
position other than “AUTO”.
. The locking procedure is performed
twice. When performing the unlocking
procedure after performing the locking
procedure, perform the locking procedure
twice again.
*1: The setting for the period of time in which the
low beam headlights remain on by the welcome
lighting function can be changed by a SUBARU
dealer. Contact your SUBARU dealer for de-
tails.
! Sensor for the auto on/off head-
lights (if equipped)
The sensor is on the instrument panel as
shown in the illustration.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light cor-
rectly and the auto on/off headlights
may not operate properly.
& High/low beam change
(dimmer)
1)
2)
High beam
Low beam
When the headlights are on high beam, the
high beam indicator light “ ” on the
combination meter is also on.