Instruments and controls/Meters and gauges
If the ECO gauge moves towards the +
side, this indicates better fuel efficiency.
NOTE
. The ECO gauge shows only an
approximate indication of fuel effi-
ciency.
. After resetting the trip meter, the
average rate of fuel consumption is not
shown until you have driven for 1 mile
(or 1 km). Before that time, the ECO
gauge does not operate.
& Combination meter settings
Meter and vehicle settings can be set on
the combination meter.
! Type A combination meter
Various adjustments can be made, such
as switching units shown on the combina-
tion meter and adjusting the warning tone
volume.
While the ignition switch is in the “OFF”
position, each press of TRIP RESET
switch results in items shown in the table
below being switched.
Item
Combination
meter display
Possible
settings
A trip —
B trip —
Gauge
needle
sweep
function On/Off
Changing
the unit* mile/km
Warning
volume* Lv. 1/Lv. 2/Lv. 3
3-11
! Switching method
1. Push the ignition switch in the “OFF”
position.
*: if available
NOTE
. If you switch the units on the combi-
nation meter, the units on the multi-
function display (black and white) also
switches accordingly.
. If either of the following conditions
is met, the combination meter setting
mode will be canceled.
– The driver’s door is opened.
– The TRIP RESET switch is not
operated for approximately 10 sec-
onds or more.
1)
TRIP RESET switch
2. Press the TRIP RESET switch repeat-
edly until the item you want to change is
displayed.
3. Press and hold the TRIP RESET
switch while the item to be changed is
displayed, the setting of the item will be
switched.
! Type B combination meter
Meter and vehicle settings can be set on
the combination meter display (color
LCD). Refer to “Menu screens” F3-38.