Keys and doors/Alarm system
seconds without releasing the switch. The
setting will then be changed as follows. & If you have accidentally trig-
gered the alarm system
. Type A combination meter ! To stop the alarm
Do any of the following operations:
. Press any button on the access key fob/
remote transmitter.
. Turn the ignition switch to the “ON”
position (models without “keyless access
with push-button start system”).
. Turn the push-button ignition to the
“ACC” position (models with “keyless
access with push-button start system”).
Setting
status
Combination
meter display
Horn
Activate ALon Once
Deactivate ALoF Twice
. Type B combination meter
Setting
status
Combination
meter display
Horn
Activate AL ON Once
Deactivate AL OFF Twice
NOTE
You may have the above setting change
done by your SUBARU dealer.
NOTE
Only registered keys will stop the
alarm. If the immobilizer transponder
is not registered, the alarm will not
stop.
2-27
& Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. Refer to “Alarm system
setting” F2-26. The security indicator light
will continue to flash once every 3 seconds
indicating that the system is in the valet
mode.
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. Refer to “Alarm system setting” F2-
26.