9-18
In case of emergency/Rear gate – if the rear gate cannot be opened
button start system is deactivated, press
the push-button ignition switch with the
brake pedal released. The status of the
push-button ignition switch then changes
to “ON”.
If the power status does not switch
even though the above procedure was
followed precisely, contact your
SUBARU dealer.
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound. At the same
time, the push-button ignition switch turns
to the “ACC” or “ON” position.
5. After the push-button ignition switch
turns to the “ACC” or “ON” position, while
depressing the brake pedal, press the
push-button ignition switch.
& Starting engine
NOTE
1. Apply the parking brake.
2. Shift the select lever into the “P”
position.
3. Depress the brake pedal.
If the engine does not start even
though the above procedure was followed precisely, contact your SUBARU
dealer.
NOTE
Rear gate – if the rear gate
cannot be opened
In the event that you cannot open the rear
gate by operating the rear gate opener
button, you can open it from inside the
cargo area.
1. Remove the access cover at the
bottom-center of the rear gate trim using
a flat-head screwdriver wrapped with vinyl
tape or a cloth.
2. Locate the rear gate open lever behind
the rear gate trim panel.
4. Hold the access key with the buttons