7-48
Starting and operating / BSD / RCTA
time by pressing the“ RES / SET” switch to the“ SET” side quickly.
NOTE
If the“ RES / SET” switch is repeatedly operated quickly to the“ SET” side, the set vehicle speed displayed in the combination meter becomes the low speed setting. However, when the set vehicle speed is set to a speed much lower than the actual vehicle speed, the set speed may be reset to the actual vehicle speed.
! To decrease the speed( by brake pedal)
1. Depress the brake pedal to release cruise control temporarily.
2. When the speed decreases to the desired speed, press the“ RES / SET” switch to the“ SET” side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.
& Cruise control indicator light
Refer to“ Cruise control indicator light” F3-31.
& Cruise control set indicator light
Refer to“ Cruise control set indicator light” F3-31.
BSD / RCTA( if equipped)
The BSD / RCTA consists of rear radar with Blind Spot Detection and Rear Cross Traffic Alert.
These functions enable the system to detect objects or vehicles to the rear, drawing attention to the driver when changing a lane or when driving in reverse.
WARNING
The driver is responsible for driving safely. Always be sure to check the surroundings with your eyes when changing lanes or reversing the vehicle.
The system is designed to assist the driver in changing lanes or reversing safely by monitoring the rear and side areas of the vehicle. However, you cannot rely on this system alone in assuring the safety during a lane change or reversing. Overconfidence in this system could result in an accident and lead to serious injury or death. Since the system operation has various limitations, the flashing or illumination of the BSD / RCTA approach indicator light