3-90
Instruments and controls/Light control switch
. 3 minutes have passed since the low
beam headlights were illuminated by the
welcome lighting function.
. 30 seconds have passed since the
door is opened and closed.*1
. The light control switch is turned to a
position other than “AUTO”.
. The locking procedure is performed
twice. When performing the unlocking
procedure after performing the locking
procedure, perform the locking procedure
twice again.
*1: The setting for the period of time in which
the low beam headlights remain on by the
welcome lighting function can be changed by a
SUBARU dealer. Contact your SUBARU dealer
for details.
! Sensor for the auto on/off headlights (if equipped)
& High/low beam change
(dimmer)
The sensor is on the instrument panel as
shown in the illustration.
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “ ” on the combination meter is also on.
To switch back to low beam, pull the lever
back to the center position.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light correctly and the auto on/off headlights
may not operate properly.