Keys and doors/Remote keyless entry system
the ignition switch at least 6 times within
10 seconds after Step 2.
4. Open and close the driver’s door once
within 10 seconds after Step 3.
5. The hazard warning flashers flash 3
times to indicate completion of the setting.
You may have the above settings done by
your SUBARU dealer. Also, for models
with a multi function display, the setting
can be changed using the display. For
details, refer to “Keyless buzzer volume
setting” F3-78.
& Replacing the battery
Refer to “Replacing key battery” F11-42.
& Certification for remote keyless entry system
2-25
! Canada-spec. models
! U.S.-spec. models
FCC ID: CWTWB1U811
FCC ID: CWTWD1U781
CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the
equipment.
& Replacing lost transmitters
NOTE
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), your transmitters should be reprogrammed for security
reasons. For details, contact your
SUBARU dealer and have the transmitters
programmed into the remote keyless entry
system.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
– CONTINUED –