Subaru Crosstrek Manuals 2016 Crosstrek Hybrid Owner's Manual | Page 429

9-12 In case of emergency/In case of a flat tire compressor’s power switch (1), wait a few seconds, and then press the “ ” (off) side of the switch. 28. If the tire pressure is 18 psi (130 kPa) or more, adjust the tire to the specified pressure on the tire placard. If the tire pressure is less than 18 psi (130 kPa), the tire cannot be repaired with sealant. Do not continue to drive your vehicle. Contact a SUBARU dealer or Commercial Road Service for assistance. NOTE 25. Insert the power cord of the compressor (3) into the accessory power outlet (10). 26. Set the ignition switch to the “ACC” position. In cold weather, more time might be required to complete a repair, and you might need to drive a longer distance. In this case, repeat the Steps from (19) to (27). If the pressure continues to drop even after repeating this procedure, the tire cannot be repaired with the repair kit. Do not continue to drive the car. Contact a SUBARU dealer or Commercial Road Service for assistance. 29. After sealing the flat tire, immediately have your vehicle inspected at a SUBARU dealer or other qualified service facility. CAUTION 27. Press the “ ” (on) side of the . Drive carefully, obeying legal speed limits, never driving faster than 50 mph (80 km/h), and avoiding sudden steering movements. . Do not exceed a maximum driving distance of 125 miles (200 km) on a sealant-filled tire. NOTE . After sealing the flat tire temporarily, have the tire repaired or replaced with a new tire and tire valve as soon as possible. . When a tire is repaired with liquid sealant, the tire pressure warning valve and transmitter may not operate properly. If a liquid sealant is used, contact your nearest SUBARU dealer or other qualified service shop as soon as possible. Make sure to replace the tire pressure warning valve and transmitter when replacing the tire. You may reuse the wheel if there is no damage to it and if the sealant residue is properly cleaned off. . The sealant, hose, speed limit label, and sealant application cap need to be replaced after using the flat tire repair kit. Contact a SUBARU dealer for details.