Subaru Crosstrek Manuals 2016 Crosstrek Hybrid Owner's Manual | Page 122

Keys and doors/Remote keyless entry system & Unlocking Perform steps 1 to 5 described in “Registration”. NOTE . You cannot unlock by PIN Code Access in the following cases. – when the access key is within the operating ranges – when the ignition switch is in the “ACC” or “ON” position . If you make an operation error during the unlocking procedure, start over with the unlocking procedure after waiting for 5 seconds or longer. . To protect your vehicle from theft, a buzzer will sound if incorrect PIN codes are entered five times continuously. If this occurs, you cannot unlock the doors by PIN Code Access for 5 minutes. Remote keyless entry system CAUTION . Do not expose the access key to severe shocks, such as those experienced as a result of dropping or throwing. . Do not take the access key apart except when replacing the battery. . Do not get the access key wet. If it gets wet, wipe it dry with a cloth immediately. . When you carry the access key on an airplane, do not press the button of the access key while in the airplane. When any button of the access key is pressed, radio waves are sent and may affect the operation of the airplane. When you carry the access key in a bag on an airplane, take measures to prevent the buttons of the access key from being pressed. 2-19 following functions. . Locking and unlocking the doors (and rear gate) . Unlocking the rear gate . Sounding a panic alarm . Arming and disarming the alarm system. For detailed information, refer to “Alarm system” F2-21. The operable distance of the remote keyless entry system is approximately 30 feet (10 meters). However, this distance will vary depending on environmental conditions. The system’s operable distance will be shorter in areas near a facility or electronic equipment emitting strong radio waves such as a power plant, broadcast station, TV tower, or remote controller of home electronic appliances. NOTE The remote keyless entry system will not be activated when the push-button ignition switch is in any position other than the “OFF” position. The access key is used as the transmitter for the remote keyless entry system. The remote keyless entry system has the – CONTINUED –