Climate control/Defrosting
Defrosting
& Type A and B
Select the “ ” or “ ” mode by turning the
airflow mode selection dial to defrost or
dehumidify the windshield and front door
windows.
& Type C
Select the “ ” mode by pressing the
defroster button, or select the “ ” mode
by turning the airflow mode selection dial
to defrost or dehumidify the windshield
and front door windows.
& Type D
Select the “ ” mode by pressing the
defroster button, or select the “ ” mode
by pressing the airflow mode selection
button to defrost or dehumidify the windshield and front door windows.
NOTE
. When the “ ” or “ ” mode is
selected, the air conditioner compressor operates automatically regardless
of the position of the air conditioner
button to defrost the windshield more
quickly. However the indicator on the
air conditioner button will not illuminate. At the same time, the air inlet
selection is automatically set to the
outside air mode.
For type A climate control system, in
this state:
– You cannot stop the air conditioner compressor by pressing the
air conditioner button.
– You cannot select the recirculation mode by pressing the air inlet
selection button.
. For type C and D climate control
system, after defrosting the windshield
by pressing the defroster button “ ”,
pressing the button again returns the
system to the setting that had been
selected before the defroster was activated.
4-11
Operating tips for heater and
air conditioner
& Cleaning ventilation grille
1)
Front ventilation inlet grille
Always keep the front ventilation inlet grille
free of snow, leaves, or other obstructions
to ensure efficient heating and defrosting.
Since the condenser is located in front of
the radiator, this area should be kept clean
because cooling performance is impaired
by any accumulation of insects and leaves
on the condenser.
& Efficient cooling after parking
in direct sunlight
After parking in direct sunlight, drive with
the windows open for a few minutes to
– CONTINUED –