BRZ _ U. book 194 ページ 2024 年 6 月 14 日 金曜日 午前 9 時 14 分
194
Mirrors ▽ Reprogramming a Single HomeLink ® button
To program a previously trained button, follow these steps:
1. Press and hold the desired
HomeLink ® button. DO NOT release the button.
2. The indicator light will begin to slowly flash orange after 20 seconds. The
HomeLink ® button can be released at this point. Proceed with“ Programming a New
HomeLink ® button”- step 3.
3. If you do not complete the programming of a new device to the button, it will revert to the previously stored programming. ▽ Garage Door Two-Way Communication
HomeLink ® has the capability of communicating with your garage door opener.
HomeLink ® can receive and display“ closing” or“ opening” status messages from compatible garage door opener
systems. At any time, HomeLink ® can also recall and display the last recorded status communicated by the garage door opener to indicate your garage door being“ closed” or“ opened”.
HomeLink ® has the capability of receiving this communication from the garage door opener at a range up to 820 feet( 250 m). Range may be reduced by obstacles such as houses or trees. You may have to slow your vehicle speed to successfully receive the garage door opener communication. ▽ Programming Two-Way Communication
1
1) Status Indicators
304874
Within 5 seconds after programming a
new HomeLink ® button, both of HomeLink’ s garage door status indicators will flash rapidly green indicating that the garage door two-way communication has been enabled. If your garage door status indicators flashed, two-way communication programming is complete.
If
fl a o w R re
c n
a d s
If s