BRZ _ U. book 135 ページ 2024 年 6 月 14 日 金曜日 午前 9 時 14 分
NOTE
� When the control dial is turned fully upward, the illumination brightness becomes the maximum and the automatic dimming function does not work at all. � The brightness setting is not canceled even when the ignition switch is turned to the“ OFF” position.
■ Auto Dimmer Cancel Function
When the ambient light is bright, the illumination brightness is set to the maximum regardless of the position of the control dial. In this case, you cannot adjust the illumination brightness by using the control dial. When the ambient light is dark, you can dim the illumination brightness as described above.
The operational / non-operational setting and sensitivity of the auto dimmer cancel function can be changed by your SUBARU dealer. Contact your SUBARU dealer for details.
3-6. Warning and Indicator Lights Several of the warning and indicator lights illuminate momentarily and then go out when the ignition switch is initially turned to the“ ON” position. This permits checking the operation of the bulbs.
Apply the parking brake and turn the ignition switch to the“ ON” position. For the system check, the following lights illuminate and turn off after several seconds or after the engine has started:
: Seatbelt warning light( The seatbelt warning light turns off only when the driver fastens the seatbelt.)
: Front passenger’ s seatbelt warning light( The seatbelt warning light turns off only when the front seat passenger fastens the seatbelt.)
: Rear passenger’ s seatbelt warning light( The seatbelt warning light turns off only when the rear seat passenger fastens the seatbelt.)
: SRS airbag system warning light
: Front passenger’ s frontal airbag ON indicator light
: Front passenger’ s frontal airbag OFF indicator light
/: CHECK ENGINE warning light / Malfunction indicator light