BRZ _ U . book 255 ページ 2022 年 3 月 29 日 火曜日 午後 3 時 59 分
■ When Initialization of the Tire Pressure Monitoring System has Failed
Initialization can be completed in a few minutes . However , in the following case , the settings have not been recorded and the system will not operate properly . If repeated attempts to record tire inflation pressure settings are unsuccessful , have the vehicle checked at your SUBARU dealer .
� When operating the TPMS set switch , low tire pressure warning light does not blink 3 times .
� After carrying out the initialization procedure , the low tire pressure warning light blinks for 1 minute then stays on after driving for 20 minutes . WARNING
Do not operate the TPMS set switch without first adjusting the tire inflation pressure to the specified level . Otherwise , the low tire pressure warning light may not come on even if the tire inflation pressure is low , or it may come on when the tire inflation pressure is actually normal .
■ Registering ID Codes
Every tire pressure warning valve and transmitter has a unique ID code . In addition to the set of tire pressure monitoring system sensor ID codes initially registered to the vehicle , a second set of ID codes can be registered .
A second set of tire pressure monitoring system sensor ID codes can be registered at your SUBARU dealer . When 2 sets of ID codes have been registered , either ID code set can be selected .
■ Changing the ID code set 1 . Park the vehicle in a safe place and turn the ignition switch to the “ ON ” position .
2 . Press the TPMS set switch 3 times within 3 seconds .
3 . The low tire pressure warning light will illuminate for 3 seconds and then blink 3 times .
4 . The low tire pressure warning light will blink for 1 minute and then illuminate .
5 . When the ID code change has completed , the tire pressure monitoring light will turn off .
Check that tire pressures are displayed on the TPMS screen .