BRZ _ U . book 191 ページ 2022 年 3 月 29 日 火曜日 午後 3 時 59 分
Proceed with “ Programming a New HomeLink ® button ” step 4 to complete . ▽ Using HomeLink ® To operate , simply press and release the
programmed HomeLink ® button . Activation will now occur for the trained device ( i . e . garage door opener , gate operator , security system , entry door lock , home / office lighting , etc .). For convenience , the hand-held remote of the device may also be used at any time .
▽ Erasing HomeLink ® buttons
To erase programming from the three buttons ( individual buttons cannot be erased but can be “ reprogrammed ” as outlined below ), follow the step noted :
Press and hold the two outer HomeLink ® buttons for at least 10 seconds . The LED indicator will change from continuously lit to rapidly flashing . Release both buttons . Do not hold for longer than 20 seconds .
HomeLink ® is now ready to be programmed at any time beginning with
“ Programming a New HomeLink ® button ” - step 1 .
▽ Reprogramming a Single HomeLink ® button
To program a previously trained button , follow these steps :
1 . Press and hold the desired
HomeLink ® button . DO NOT release the button .
2 . The indicator light will begin to slowly flash orange after 20 seconds . The
HomeLink ® button can be released at this point . Proceed with “ Programming a New
HomeLink ® button ” - step 3 .
3 . If you do not complete the programming of a new device to the button , it will revert to the previously stored programming . ▽ Garage Door Two-Way Communication
HomeLink ® has the capability of communicating with your garage door opener .
HomeLink ® can receive and display “ closing ” or “ opening ” status messages from compatible garage door opener
systems . At any time , HomeLink ® can also recall and display the last recorded status communicated by the garage door opener to indicate your garage door being “ closed ” or “ opened ”.