BRZ _ U . book 184 ページ 2022 年 3 月 29 日 火曜日 午後 3 時 59 分
184
Wiper and Washer and to remove accumulations of road salt or road film . Operate the windshield washer for at least 1 second so that washer solution will be sprinkled all over the windshield or rear window . � Grease , wax , insects , or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass . If you cannot remove the streaks after operating the windshield washer or if the wiper operation is jerky , clean the outer surface of the windshield using a sponge or soft cloth with a neutral detergent or mild-abrasive cleaner . Do not , however , use detergent to clean the blade rubbers . Use only a sponge or soft cloth ( and no neutral detergent or mild abrasive cleaner ) when you clean the blade rubbers . If you wipe the rubber of the blade strongly , the black coating component will peel off , which will cause the wiper to judder . Also , after wiping it off , check that the rubber has not come loose . After cleaning the window glass and wiper blade rubbers , be sure to rinse them with clean water . Rinse the window until the water does not form beads on the glass . This indicates that the glass is clean . � If you cannot eliminate the streaking even after following this procedure , replace the wiper blades ( or blade rubbers ) with new ones . For replacement instructions , refer to " Replacement of Wiper Blades " �P367 . � If the wipers do not operate in the following conditions , turn the wiper switch to the “ ” position . - The wiper switch is in the “ ” position , however , it does not work . - The wiper switch is in the “ ” position , however , it does not work . In these cases , contact your SUBARU dealer . ■ Windshield Wiper and Washer Switches
The wiper operates only when the ignition switch is in the “ ON ” position .
▼ Windshield wipers
301723
T c
T th
F le re
▼
W ti in