1-2. Opening, closing and locking the doors and trunk lid
Alarm
Situation
Correction procedure
Exterior alarm
sounds once for
5 seconds
An attempt was made to
lock the vehicle while a
door was open.
Close all of the doors
and lock the doors
again.
Interior alarm
sounds continuously
The push-button ignition
switch was turned to
“ACC” mode while the
driver’s door was open (or
the driver’s door was
opened while the pushbutton ignition switch was
in “ACC” mode).
Turn the push-button
ignition switch off and
close the driver’s
door.
■ Security feature
If a door is not opened within approximately 60 seconds after the vehicle is
unlocked, the security feature automatically locks the vehicle again. (However, depending on the location of the access key, the key may be detected
as being in the vehicle. In this case, the vehicle may be unlocked.)
■ Battery-saving function
The battery-saving function will be activated in order to prevent the access
key battery and the vehicle battery from being discharged while the vehicle
is not in operation for a long time.
● In the following situations, the keyless access with push button start system may take some time to unlock the doors.
• The access key has been left in an area of approximately 6 ft. (2 m) of
the outside of the vehicle for 10 minutes or longer.
• The keyless access with push button start system has not been used
for 5 days or longer.
● If the keyless access with push button start system has not been used for
14 days or longer, the doors cannot be unlocked at any door except the
driver’s door.
In this case, take hold of the driver’s door handle, or use the remote keyless entry system or the mechanical key, to unlock the doors.
30