& Locking and unlocking |
S09AP01 |
& Switching power status
S09AP02
1. Apply the parking brake.
2. Shift the select lever to the“ P”( Park) position.
3. Depress the brake pedal.
|
5. When the keyless access with pushbutton start system is deactivated, press the push-button ignition switch with the brake pedal released. The status of the push-button ignition switch then changes to“ ON”. |
|
NOTE
If the power does not switch even though the above procedure was followed precisely, contact your SUBARU dealer.
|
|||
|
1 Release button 2 Emergency key
While pressing the release button of the access key fob, take out the emergency key.
Lock or unlock the driver’ s door with the emergency key in the procedure described in“ Locking and unlocking from the outside” FP138.
NOTE
After locking or unlocking, be sure to attach the emergency key back to the access key fob.
|
4. Hold the access key fob with the buttons facing you, and touch the push-button ignition switch with it. When the communication between the access key fob and the vehicle is completed, a chime( ding) will sound. At the same time, the status of the push-button ignition switch changes to either of the following.. When the keyless access with pushbutton start system is deactivated:“ ACC”
. Under other conditions:“ ON”
|
& Starting engine
S09AP03
1. Apply the parking brake.
2. Shift the select lever to the“ P”( Park) position.
3. Depress the brake pedal.
|
In case of emergency |
– CONTINUED – |