152
Rear gate
non-operation or pressing twice at SUBARU dealers. For more details, contact your SUBARU dealer.
! By the buttons on the rear gate
S02AJ011102
NOTE
After performing the following procedures, an electronic chirp will sound twice and the hazard warning flashers will flash twice.
NOTE
The rear gate cannot be paused when it is in the approximately 2 in( 5 cm) range from the fully closed position. The system will ignore any button operation and the rear gate will continue to open.
To close the rear gate:
Press and hold the power rear gate button. Then an electronic chirp will sound twice and the hazard warning flashers will flash twice. If you briefly press the power rear gate button again, the rear gate will open.
NOTE
The factory setting( default setting) of the operation for the“” button on the access key fob is pressing and holding. This setting can be changed to
Rear gate opener button
Power rear gate button on the inside edge of the rear gate
1 Power rear gate button 2 Power rear gate lock button
To open the rear gate:
When the rear gate is locked
When the rear gate is unlocked
Briefly press the rear gate opener button while carrying the access key.
Briefly press the rear gate opener button.
After you operate the rear gate, an electronic chirp will sound twice and the hazard warning flashers will flash twice.
The rear gate will open automatically.
To pause the opening rear gate:
Briefly press either of the following buttons while the rear gate is being opened.