Towing 467 |
|
! Rear towing hook
S09AF0105
1 . Take the towing hook and screwdriver out of the tool bucket . Take the jack handle out of the cargo area .
|
After towing , remove the towing hook from the vehicle and stow it in the tool bucket .
Fit the towing hook cover on the bumper .
WARNING
|
3 . Screw the towing hook into the thread hole until its thread can no longer be seen . |
. Do not use the towing hook for purposes other than towing your vehicle .
. Be sure to remove the towing hook after towing . Leaving the towing hook mounted on the vehicle could interfere with proper operation of the fuel pump shut off function when the vehicle is struck from behind .
|
|||
2 . Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch the bumper . Pry off the cover on the rear bumper using a screwdriver , and you will find a threaded hole for attaching the towing hook . |
4 . Tighten the towing hook securely using the jack handle and wheel nut wrench . |
CAUTION
. To prevent deformation to the bumper and the towing hook , do not apply an excessive load to the towing hook .
. For models equipped with the BSD ( Blind Spot Detection ) and RCTA ( Rear Cross Traffic Alert ) driving support systems , when towing another vehicle , touch “ Rear Vehicle Detection ( BSD / RCTA )” to deactivate the system . The system may not operate
|
In case of emergency |
|
– CONTINUED – |