58
Seatbelts
WARNING
Fastening the seatbelt with the webbing twisted can increase the risk or severity of injury in an accident . When fastening the belt after it is pulled out from the retractor , especially when inserting the anchor tongue plate into the mating buckle ( on right-hand side ), always check that the webbing is not twisted .
tongue plate not fastened to the anchor buckle on the right-hand side ), it cannot properly restrain the wearer in position in an accident , possibly resulting in serious injury or death .
. The head restraint is not intended to be used at the lowest position . Before sitting on the seat , raise the head restraint to the extended position . Otherwise , in an accident , serious injury or death could result .
2 . Pull out the seatbelt slowly from the overhead retractor .
WARNING
. Be sure to fasten both tongue plates to the respective buckles . If the seatbelt is used only as a shoulder belt ( with the anchor
The center seatbelt is stowed in the recess of the ceiling .
1 . Pull the anchor tongue plate out from the front side of the slot by pulling it rearward .
3 . After confirming that the webbing is not twisted , insert the anchor tongue plate attached at the webbing end into the buckle on the right-hand side until a