Light control switch 237 |
|||||
|
– Immediately after the engine has started .
. In the following conditions , the headlight mode will not be automatically changed from the high beam to the low beam . – When your vehicle passes an oncoming vehicle suddenly in a blind curve .
– When another vehicle passes in front of your vehicle .
– When an oncoming vehicle or vehicle ahead comes in and out of view because of continuous curves , median strips , roadside trees , etc .
. If the stereo camera detects the light of the front fog lights of an oncoming vehicle , the headlight mode may change from the high beam to the low beam automatically .
. The headlight mode may change from the high beam to the low beam , or the low beam mode may continue , when affected by a street light , traffic signal , illumination of an advertisement board , or a reflective object such as a road sign and signboard .
. The timing of the change of headlight mode may differ due to the following factors . – Color or brightness of the headlights of an oncoming vehicle or the tail
|
lights of a vehicle ahead .
– The headlights of the oncoming vehicle or the tail lights of the vehicle ahead are covered with mud , snow , etc .
– Movement and direction of an oncoming vehicle or a vehicle ahead .
– When the headlights of an oncoming vehicle or the tail lights of a vehicle ahead illuminate on only one side .
– When the oncoming vehicle or vehicle ahead is a motorcycle . – Conditions of a road ( slope , curve , road surface , etc .). – Number of passengers and weight of loaded cargo . – Limitation of the detection ability of the stereo camera .
& Daytime running light system
S03AH04
WARNING
|
When the daytime running lights are illuminated , the tail lights do not illuminate . When it becomes dark outside , turn the light switch to the “ ” position to illuminate the headlights and tail lights . This will improve visibility and allow other drivers to see your vehicle more easily . |
The daytime running lights will automatically illuminate when the following conditions are fulfilled .
. The engine is running . . The parking brake is fully released .
. The light control switch is in “ AUTO ”, “ ” or “ OFF ” ( for Canada models ).
. The select lever is in a position other than the “ P ” position .
NOTE
When the light switch is in the “ ” position , the instrument panel illumination , front side marker lights , tail lights and license plate lights are also illuminated .
|
Instruments and controls |