136
Remote keyless entry system
Models with “ keyless access with push-button start system ”:
If desired , you can turn the audible signal off by operating the center information display . For details , refer to “ Car settings ” FP215 . Furthermore , the volume setting of the audible signal can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
Models without “ keyless access with push-button start system ”:
Perform the following steps to deactivate the audible signal . Take the same steps to restore the function .
Steps |
Operation |
Time |
1 |
Sit in the driver ’ s seat . |
— |
2 |
Close all doors and the rear gate . |
— |
Press and hold “ |
” on |
( 1 ) |
the power locking switch . |
3
4
( 2 )
Insert the key into the ignition switch and pull it out at least 6 times .
Open and close the driver ’ s door .
Within 10 sec .
Within 10 sec .
The hazard warning flashers flash 3 times to indicate completion of the setting .
Your SUBARU dealer can perform the above procedure for you .
& Replacing the battery
Refer to “ Replacing key battery ” FP516 .
S02AE08
& Replacing lost transmitters
S02AE09
If you lose a transmitter or want to purchase additional transmitters ( up to four can be programmed ), your transmitters should be reprogrammed for security reasons . For details , contact your SUBARU dealer and have the transmitters programmed into the remote keyless entry system .
& Certification for remote keyless entry system
S02AE18
! U . S . -spec. models
S02AE1801
FCC ID : CWTB1G077 FCC ID : CWTD1G141
CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user ’ s authority to operate the equipment .
NOTE
This device complies with part 15 of the FCC Rules . Operation is subject to the following two conditions : ( 1 ) This device may not cause harmful interference , and ( 2 ) this device must accept any interference received , including interference that may cause undesired operation .