revista pdf fox 34 tuning guide Fox 34 tuning guide | Page 6

Install the Front Wheel
Wheel installation is identical for both the 15x100 mm and 15x110 mm axles.
1. Install the front wheel into the fork dropouts. Slide the axle through the non-drive
side dropout and hub.
2. Open the axle lever.
3. Turn the axle clockwise 5-6 complete turns into the axle nut.
4. Close the lever. The lever must have enough tension to leave an imprint on your hand.
5. The closed lever position must be between 1-20 mm in front of the fork leg.
6. If the lever does not have enough tension, or has too much tension when closed
at the recommended position (1-20 mm in front of the fork). See the next page for
adjustment instructions.
KABOLT INSTALLATION
1-20 mm
Wheel installation is identical for both the 15x100
mm and 15x110 mm Kabolt axles.
1. Install the front wheel into the fork
dropouts. Slide the K
 abolt axle through
the non-drive side dropout and hub.
2. Use a 6 mm hex wrench to torgque the
Kabolt axle (clockwise) to 17 Nm (150 in-lb).
WARNING: Use hand pressure only. Never use any tool to tighten the 15QR levers onto the lower legs. Over-tightening
the levers can damage the axle or fork dropouts, leading to a sudden failure with one or more of these components,
resulting in SERIOUS INJURY OR DEATH.
WARNING: Failure to secure the axle properly can cause the wheel to become detached from the bicycle, resulting in
SERIOUS INJURY OR DEATH.
6