Wall mounting
The maximum range of the device is 7 linear metres (7
metres per each side of the device) and 5 metres in width (5
metres per each side of the device).
1. Open the cover lid and pull the Polopposto device out.
2. Apply the Polopposto device low on the wall, at a
maximum height of 20‐30 cm from the floor, as shown
in the figure.
3. Using the dowels, anchor (horizontally) the cover base
to the holes provided, as shown in the figure.
4. Place the Polopposto device (parallelepiped) in the
cover base, as shown in the figure.
5. Close the device using the cover lid by applying little
pressure.
Put the Polopposto device (parallelepiped) into the cover
base, as shown in the figure:
Close the device using the cover lid by applying little
pressure.
DOWNLOD MASTER WEBSITE
The Polopposto device underwent a long series of tests
and was technologically designed to fight rising damp
from the ground on masonry of ground and underground
floors. Using the same method used by the water to rise up
masonry walls, Polopposto acts in an opposite way.
32
33
POLOPPOSTO DEVICE RANGE