Method of Usage
Gently hold the arm rest. Put in the cage ring, the big washer and then the locknut,
and tighten the bolt using a wrench (Figure 6).
Thread the socket head cap screw into the upper tightening cap (Figure 7). Then
use the provided wrench to screw in the upper supporting gear.
Connect the air pipe and the valve connector onto the iron plate of the arm rest
(Figure 8).
Check if the arm rest is positioned well, making sure nothing is loose. Close the
large and small cover back onto the outside of the arm rest (Figure 8).
Close the zipper of the lower arm rest and installation is complete.
Method of Usage
Be careful not to put weight on the two arm rests in order to support the body
(Figure 10).
Be careful not to put weight on the upper arm airbag support board (Figure 11).
7. Controller Frame Installation
Controller Tray
Screw
Frame
Controller Frame
Assembly
To begin installation, first remove the fixed screws on the controller tray (Figure 1).
Insert the ball joint of the frame to the spherical part of the controller tray (Figure 2).