Intumescent Strip Set
This cutter is designed for insetting 20 x 4mm thick , one hour check intumescent strip into doors and frames . Fitted with a 32mm guide bearing , the 40mm diameter cutter has a 1 / 2 inch diameter shank for use in handheld or table mounted routers . Alternative thickness fire / smoke check strips can be accommodated by fitting alternative diameter bearings . 345 ____________________£ 60.85
Undercut Cutters
Bearing-guided undercut cutters can be used to produce either decorative effects such as the relief highlighting of letters and symbols , or for under-cutting rebates and pockets for fitting panels or linings . Three sizes are available , two producing undercuts of 3.2 mm ( 19.1mm cutter dia ), the third producing an undercut of 6.3mm ( 25.4mm cutter dia ). All cutters are two flute Tungsten Carbide Tipped and have extra long 40mm x 1 / 4 inch shanks fitted with 12.7mm guide bearings . 30 / 2 _____£ 25.95 30 / 4 _____£ 26.95 30 / 6 _____£ 27.95
Bearing Guided Dovetail
This bearing-guided cutter is intended for use with the APTC ( Axminster Power Tool Centre - Devon ) dovetail jig . It can also be used with similar current versions of this jig supplied by Nu-tool and other manufacturers . C162A ______________£ 10.80
Bevel Trimmer
This addition to the range of bevel trimmers has a wider gap between the cutter edges and the bearing . This is designed to reduce the build-up of adhesive and prevent it from clogging the bearing . Used mainly for trimming laminates , veneers and thin facing materials , the cutter has a bevel angle of 82 ° and a shank diameter of 1 / 4 inch . 46 / 6D ________________£ 15.95
Variable Kerf
Supplied with a set of shims and spacers , these cutters can be adjusted to produce edge grooves with kerf widths from 3 to 5mm and 5 to 9mm respectively . Mounted on a 1 / 2 inch shank threaded arbor , the kerf width is altered by disassembling the cutter and inserting shims and / or spacers between the grooving blades . The interlocking two-wing grooving blades are Tungsten Carbide Tipped and the cutter is fitted with a 28mm guide bearing to produce a 11mm kerf depth . Alternative bearing diameters are available to produce a variety of kerf depths . 27 / 35 ___________£ 45.00 27 / 59 _______£ 49.00
Low Profile Trimmers
Specifically designed for use in restrictive situations where the guide bearing retaining screw on standard trimming cutters may interfere with the workpiece profile , low profile trimming cutters have a countersunk retaining screw to reduce the clearance beneath the cutter . The minimum rebate clearance when using these cutters is reduced to 8mm . Available with 1 / 4 inch shanks , both cutters are two flute Tungsten Carbide Tipped . 46 / 200 __________£ 25.95 46 / 201 __________£ 29.95
20 INProfile All prices are exclusive of VAT Spring 2002