Window Board
Moulding Cutters
Easy Set®
Profile Scribers
Additions to the
successful range of
Trend Easyset®
profile scribing
cutters, are two ovolo
styles, one with a single
quirk, the other with a
double quirk. Both cutters
are fitted with two reverse profile blocks and
one grooving blade. Mounted on a threaded
arbor, these cutters do not require
disassembling to produce the interlocking joint
profiles but by simply raising or lowering the
cutter height in the router table. Available with
1/2 inch shanks, these cutters should only be
used in table-mounted routers.
PSC/106 _______£99.50
PSC/107 _______£99.50
Four new moulding cutters have been
added to the range of decorative
moulding styles. These are the 8mm
shank modern architrave, to produce
angled face and rounded edge, a 1/4
inch shank window board cutter for
radiused edge or full nosing, a 1/4 inch
shank Queen Anne rounding over
cutter to replicate part or full nosings
of this period and a range of dual
large step rounding over and ovolo
cutters.
Each cutter is bearing-guided with the
guide bearing mounted on the nose of
the cutter. The large step cutter is
available in four sizes and supplied
with alternative bearings to produce
one rounding over radius and two
sizes of ovolo moulding. Each
cutter has a deep bottom step to
allow the moulding 'quirk' to be
adjusted using the router’s fine height
adjuster. The moulding quadrant radii
are 6.35 and 9.5mm on the smaller
pair of cutters and 9.5 and 15.9mm
on the larger 1/2 inch shank cutters.
Window Board 46/9/60 _____£29.95
Modern Architrave 46/401___£37.95
Queen Anne 46/9/50 _______£39.95
Large Step Roundover & Ovolo
40/13 ___________________£33.95
40/14 ___________________£34.95
40/15 ___________________£39.95
40/16 ___________________£45.95
Modern Architrave
Large Step
Roundover & Ovolo
90° Template Oversize
In order to prolong the cutting edge
life of your trimming cutters, excess
waste material should be trimmed to
a margin of around 3mm from the
template edge, or where a template
needs to be made larger. Fitted with
oversize shank mounted guide
bearings, these cutters are designed
to leave a template margin of 2.35 or
3.2mm respectively. Both trimming
cutters will accommodate material up
to 19mm thick and are available with
1/4 inch shanks.
26/2_____________________£25.95
26/3_____________________£27.95
Spring 2002
INProfile
21