Timber Repair Template
perfect
match
This oval template is designed for cutting both the recess and plug
for covering knots and surface blemishes. The template is simply
held in place with double-sided tape or cramps over the knot or
blemish, with the major axis along the grain. It is supplied with a
20mm guide bush, a 40mm guide bush collar and a 10mm router
cutter for cutting the matching recess and inlay. The maximum
recommended plug thickness/recess depth is 5mm. This template
can be used with the cutter/guide bush combination or any
alternative combination to inlay veneers, fittings and other
decorative features.
TEMP/TRKX1/4______£29.95
TEMP/TRKX8MM ____£29.95
Careful matching of grain
and colour will disguise
knots and blemishes in the
timber surface.
panel games
Door Rails and Panel Templates
Rail and panel templates are used to produce high
quality solid timber framed and panelled doors. Each
set comprises two templates, one for the concave rail
edge, the other for the convex panel. Seven template
widths are available to cater for different cabinet sizes
while retaining the same curve height. Using a suitable
alignment jig, these templates can also be used for
producing relief moulded simulated panel doors on
paint finish or veneered, fibre/particle board or solid
timber panel doors. Using a flush trim/profile cutter,
these templates are suitable for use with hand-held or
table mounted routers.
TEMP/PD/R/A-D___£8.95 TEMP/PD/R/E-G __£9.95
guide bush collars
Guide bush collars are used to cut and perfectly match an inlay and the
pocket or recess to receive it. This is achieved using a single straight
cutter, a guide bush and a guide bush collar. The inlay is cut using just
the cutter and guide bush. A collar is then fitted over the guide bush to
increase its diameter for cutting the recess. It is not only decorative
veneers and timber panels that can be inlayed in this way. Laminate
finishes, plastics, and even soft metals can be cut in this way, to effect
repairs to damaged surfaces, to cover fastenings and fittings or again to
create further decorative effects.
Collars and guide bushes are available from Trend in three sizes.
A 40mm guide bush with a 20mm collar is used with a 10mm cutter, a
16mm guide bush and 30mm collar for use with a 7mm cutter and a
7.9mm (5/16 inch) diameter guide bush with a 14.3mm (9/16 inch) collar
and 3.2mm (1/8 inch) cutter. Collars consist of an aluminium ring,
grooved on the inside to ta