NEW LOWER
PRICE
£65.00 + VAT
Combination Cutters
guiding tip and a 90° - 60° cutter that
will flush cut or bevel simply by
adjusting the cutting depth. These
cutters have fairly short cutting edge
lengths (10mm and 6mm respectively).
Combi Cutters
These cutters perform two functions:
First they trim the overlay flush, then
they can bevel at various angles.
Some types have a bottom cut to trim
the upstand and others have bearings
for self-guiding work.
Pierce and Trim Cutters
Combination pierce and trim cutters
are used for cutting internal apertures
when fitting basins, hobs and other
inset units. These cutters are
designed to drill through and cut
around the laminate facing, following
the outline of a pre-cut aperture
beneath. The laminate is applied over
the whole top and the adhesive
allowed to dry, before the laminate is
cut away. When applying laminates it
is common practice to apply a
balancing veneer or laminate to the
reverse face to prevent bowing.
Apertures can then be cut in a similar
fashion as before, but using a twin
cutting edge pierce and trim cutter to
cut through both the face laminate
and balancer at the same time.
Template Profiling
Cutters
Intended for template work, these
trimming cutters offer a more direct
alternative to guide bushes. When
using these cutters the template is
made to the exact size required.
Templates must be secured to the
material firmly by clamping, pining or
gluing. Hot melt glue will hold well
and can be easily removed afterwards.
For small projects, double-sided
adhesive tape can be used. Both
template profiling cutters with shank
mounted bearings and trimming
cutters with their tip mounted
bearing can be used for template
work, either fitted in an inverted
router table, overhead router or
handheld.
When using the handheld method,
ensure that the workpiece is safely
secured to the bench. IP
When trimming laminates, it will
lessen the stress and wear on
your cutter if you limit the
overhang to no more than 3mm,
removing any excess before
trimming. A bearing
guided overlap
trimmer ref. 46/19
can be used for
this purpose.
mini
mach
The portable clamping
bed powered by a
workshop vacuum
extractor.
I Fast, simple obstruction free
clamping when routing,
sanding and sawing.
I Powered by a workshop
vacuum extractor.
I Holds sheet materials up to
1220mm x 1220mm down to
95mm x 95mm.
I Can be fitted to any
workbench or secured to any
flat surface.
NEW APPLICATION
Ideal for shaping small
items to a template.
Now includes 2.5 metres of
template gasket for template
copying. Using vacuum power,
the gasket enables the workpiece
to be held down onto a template
which in turn is held securely by
the Minimach.
Extra seal available:
MMACH/SEAL/1 ____£1.95
23