Hot Gas to Liquid Heat Pipe Exchanger :
The Hot Gas to Liquid heat pipe exchanger consists of Air to Air unit and the only difference is
that liquid/water insulated tank is provided to contain media at the condensation section in order
to preheat liquid / water.
Maniks heat pipe exchanger is capable to recover 85% of exhausted thermal energy which is
otherwise wasted in the atmosphere.
With special materials used for construction of the tube, the heat exchanger may be designed to
extend up to the range 427℃ to 482℃.
Heat Pipe Panel Cooler (HPPC):
Electrical and electronics operated control panels are made air tight in order to protect our costly
electronic and electrical operated devices from dust. The parts inside the electronic devices get
overheated which thus leads to failure or mal-function. So the Maniks Control panels coolers are
able to extract overheat from inside panel without disturbing the inside environment of the
panel.
Heat Pipe Dehumidifier (HPD):
In an air conditioning and refrigeration system, the moisture is condensed out, when the air
becomes colder and colder. The heat pipe is customized to have one cold outgoing stream and
one warm incoming stream. Therefore by transmitting the heat, from warm air to the cooled
outgoing stream supply air, the heat pipe exchangers are responsible to create double effect of
pre-cooling the working air, before it goes to the evaporator section and finally re-heating it
immediately. This lowers the heating load, cooling load, and evaporating temperature.
Thus Heat pipe Dehumidifier results in effective energy savings. Typically, for each 1℃ rise in
the thermostat setting, there is 3% savings in electricity/energy cost. In addition to this, the pre-
cooling effect of heat pipe exchangers allows the use of a smaller compressor which also
increases the condenser life and capacity.