Section 1
Using Re?ector Software
First Time Re?ector Setup
You will receive a code for Reflector which is required to make the software work. Follow these steps to ensure the software is
ready to use
1.
Go to All Programs and locate Reflector or doubleclick it from the launcher.
10. Click OK.
How Does the Software Work?
The Reflector software is installed on your computer. The iPad will reflect onto your computer and your projector will display the iPad.
Getting Ready to Display Your iPad
1.
Check to see if the Reflector software is running by looking for the
monitor icon in the right-hand corner. If not, launch it from
your launcher or go to All Programs/>Reflector>Reflector
This makes the software run in the background and will display the Reflector icon in the bottom right hand of the screen.
This MUST be running for the iPad to display.
2.
Click the Reflector icon to begin running the software.
3.
Locate the email with the long code.
Copy the code as directed.
2.
When prompted by the Reflector software, paste the code into the Registration window.
Mirroring Your iPad
5.
Click Register.
1.
Ensure the Reflector software is running on your computer
6.
You should notice a pinkish monitor
logo in the bottom right-hand corner
of your screen (near the time).
2.
Turn on your projector to
display your computer
screen.
7.
Right-click on this icon.
3.
8.
Choose Properties.
Your iPad should be
turned on and ready.
9.
Ensure the “Optimize For” field has
iPhone (320x480) chosen. DO NOT change the setting from
iPhone to iPad or movies may flash like a strobe light.
4.
To get to the AirPlay
icon, swipe up from the
bottom of your iPad
screen.
4.
50