global Laptop and motherboard repair tutorial | Page 33

You will wedge the pick in between the seam of the frame and screen panel top side. Slightly pry
upward near one of the imprinted tabs on the frame and push outward away from the front of the
screens glass panel. Do not force this frame away or you might crack the screen. Go Slow, Have
Patience and you will easily be able to separate this frame… Slide the pick back and forth from the
right side end of the frame to the left end side. Then you can do the same to the sides, though start
from the top and work your way down the sides pushing the frame away while you are going… The
frame will fall in front of the display panel (not literally ―fallǁ). You can now, either, pull the frame
away and set a side, or you can leave it attached to the bottom framing tape but just flip it down on the
table while holding the screen up at a 90% angle.
You will now see an aluminum bulb guard on the rear upper side of the screen. This can
sometimes have a micro sized screw on each side so look real close for one and remove it. Now,
right where the screw you just removed was, flip the screen to the side and parallel with the bulb
guard screw will be a screw on the side of the screen again it will be a micro sized screw and will
need to be removed, the same goes for the opposite side of the screen, then again there might be a
second screw on the side of the screen towards the bottom of the side. Some will have these and
some will not.