System Construction
Product Codes
Introduction
MST cable mats should be installed in a sand bed or concrete
slab depending on application.
MST Mats, 230V, 500mm wide
5
6
1. Hardened surface, e.g. interlocking pavement
2. Humidity sensor ( water, snow, ice )
3. Sand bed of the interlocking pavement
4. Concrete slab ( protects the heating cable from vehicle load )
5. ECOFLOOR MST mat
6. Firm gravel base ( macadam )
R
Pavement
The cables should be installed in sand bed just below the
concrete pavior.
ECOFLOOR pavement
R
1
2
MTS300/1.5
1.5
3.0
75.82
600
MTS300/2.0
2.0
4.0
96.27
900
MTS300/3.0
3.0
6.0
125.16
1200
MTS300/4.0
4.0
8.0
140.80
MTS300/5.0
5.0
10.0
182.11
MTS300/6.0
6.0
12.0
214.40
MTS300/7.0
7.0
14.0
234.89
MTS300/8.0
8.0
16.0
249.91
2700
MTS300/9.0
9.0
18.0
284.82
MTS300/10.0
10.0
20.0
303.07
3600
MTS300/12.0
12.0
24.0
372.47
MTS300/15.0
15.0
30.0
418.80
6000
4
450
4500
3
Price ex
VAT (£)
2400
2
Length
(m)
3000
1
Area (m2)
2100
ECOFLOOR driveway
R
Product
Code
1800
For driveways intended to take the weight of vehicles we
recommend the cables are installed in a concrete slab for
protection. The cable mats should be installed between 2 layers
of concrete. Install the cable mat over the bottom layer and then
pour the top layer of concrete. The concrete mixture must not
contain sharp stones as these may damage the cable.
Output
(W)
1500
Driveway
MTS300/20.0
20.0
40.0
638.82
Simply melt away the ice and snow.
An ice detector for the economical
control of ice prevention and snow
melting cables used on driveways,
ramps and exterior steps. The use
of an ice detector will reduce
energy consumption by
approximately 80% compared to
control by a simple air thermostat.
Ice Detector &
Combined Sensor
The ice detector, equipped with a
combined temperature and moisture
ground sensor, monitors conditions and determines the optimum
switch-on time so that the heating comes on in good time to
prevent ice formation Unnecessary waste of energy is avoided as
the system is only activated when there is ice or snow present.
Accessories
3
Max
Load
(W)
Price
ex VAT
(£)
Single channel automatic
ice detector
3600
220.00
IDC200
Two channel automatic
ice detector
11000
330.00
IDCGS
5
Description
IDC100
4
Product
Code
Combined temperature &
moisture sensor
275.00
1. Hardened surface, e.g. paviors
2. Humidity sensor ( water, snow, ice )
3. Sand fill and the sub-base of the cable
5. ECOFLOOR MST mat
5. Firm gravel base ( macadam )
R
call our sales team on 01592 760928 or email [email protected]
11