INSTALLATION INSTRUCTIONS
Z-BAR TO Z-BAR
Install Z-Bars using appropriate mechanical fasteners for
the mounting surface. Cut Z-Bars to desired lengths, and
use drops as needed.
Fir out hardware to compensate for uneven walls/ceilings,
assuring proper face alignment.
Install panel by holding against wall and lowering into place
to engage clips. Ensure that all Z-Bars are engaged.
Add a ‘dab’ of adhesive to mating Z-Bar surfaces to prevent
unwanted movement.
For ceiling applications ensure panels are positively locked
to prevent disengagement. Some common examples used
in the field are as follows: Install single pieces or
continuous runs of standard ceiling grid wall angle along the
edge of the panels, or purchase fabric-covered angle; install
wood trim along the panel edges; install a locking screw (by
others) into the ceiling at the outside panel edge. Use a
drywall screw into a ceiling joist or a screw-wall anchor
combination.
The following are guidelines given in good faith to help avoid
common errors. They are not intended to be a step-by-step list
of instructions or a checklist, and it is assumed the installer has
general construction knowledge. Conwed Designscape|Wall
Technology bears no responsibility for any installation actions
taken or not taken [