INSTALLATION INSTRUCTIONS
IMPALING CLIP/
ADHESIVE WITH RESIN SPOTS
6. Use the following guide to determine the number of clips
per panel:
;MHXL
'PMTW
The following are guidelines given in good faith to help
avoid common errors. They are not intended to be a stepby-step list of instructions or a checklist, and it is assumed
the installer has general construction knowledge. Conwed
Designscape|Wall Technology bears no responsibility for any
installation actions taken or not taken, and is not responsible
for installer selection.
,IMKLX
7. Installers of Conwed Designscape|Wall Technology
products have successfully used the following construction
mastics: PL 200, PL 400 (faster acting), Chemrex 200 and
others. (This is not a product endorsement.)
8. Panels are supplied with chemically hardened resin spots
on the panel back. Using resin spots, place a 2” diameter
dab of construction mastic on each hardened spot.
9. Position the panel against the wall, tilt back to release the
solvents and then reposition. Temporary support will likely
be required to prevent panel slippage (When Impaling
Clips are not used).
10. Use perimeter adhesive as a wet shim to help align the
panel faces.
Contact your local representative for ceiling application.
HANDLING AND STORAGE
Handle individual panels ‘on edge’ to avoid bending when
moving and carrying.
Store panels on a flat, dry, solid surface. Do not store on
edge.
Take necessary measures to keep panels dry, clean and free
from dust. Pay special attention to edges.
INSTALLATION
1. The wall surface must be dry and free from dirt, dust,
grease, loose paint, or any foreign matter that would
interfere with a good adhesive bond. If the wall surface
is not reasonably flat then panel alignment will be
compromised.
2. Snap lines on wall both vertically and horizontally keeping
lines plumb and square to c