Product Data Sheet
LOW FREQUENCY TUNER
WALL AND CEILING PANELS
PART 1 GENERAL
1.1 Work in this section shall be subject to drawings, general
conditions, schedules, addenda and other contract
documents.
1.2 The extent of the acoustical panels is shown on the
drawings and in the schedules.
1.3 Submit _______ (select quantity) samples of each type of
acoustical panel as shown on the drawings and in schedules
and include appropriate technical information including test
data and maintenance instructions. Submit __________
(select quantity) fabric selector cards from manufacturer’s
standard finishes, or designer specified finishes.
1.4 Acoustical panels shall be installed according to
manufacturer’s recommendations and instructions.
1.5 Installation of acoustical panels shall not begin until all wet
work (plastering, concrete, etc.) is completed and dry.
Building shall be properly enclosed and under standard
occupancy conditions (temperature of 60-85°F and not
more than 70% relative humidity) before installation begins.
1.6 The contractor shall be responsible for the examination
and acceptance of all surfaces and conditions prior to the
acoustical panel installation.
1.7 Substitutions or changes will only be permitted by prior
approval by the architect.
PART 2 MATERIALS
2.1 Acoustical wall panels shall be: Low Frequency Tuner
Panels as manufactured by Conwed Designscape|Wall
Technology, 800 Gustafson Road, Ladysmith, WI 54848.
Phone (800) 932-2383, fax (800) 833-4798.
2.4 Edge profile shall be: Square, radius, full bevel, halfbevel, miter, or custom __________________ (specify).
Corner detail shall be: Square, radius or custom
_______________ (specify). Edge treatment shall be:
resin hardened, aluminum or high-pressure laminate (with
square edge only), wood (all profiles available) or custom
_______________ (specify).
2.5 Panel finish shall be _______________________________
_________ (specify finish manufacturer, pattern, color and
specifier). Finish shall be applied directly over the face and
edges of the panel and returned to the back of the panel
to provide a full finished edge. All corners are fully tailored.
2.6 Mou