Product Data Sheet
RESPOND® IR SERIES
IR108/IR308/IR408
PART 1 GENERAL
1.1 Work in this section shall be subject to drawings, general
conditions, schedules, addenda and other contract
documents.
1.2 The extent of the acoustical panels is shown on the
drawings and in the schedules.
1.3 Submit _______ (select quantity) samples of each type
of acoustical panel as shown on the drawings and in
schedules and include appropriate technical information
including test data and maintenance instructions. Submit
__________ (select quantity) fabric selector cards from
manufacturer’s standard finishes, or designer specified
finishes.
1.4 Acoustical panels shall be installed according to
manufacturer’s recommendations and instructions.
1.5 Installation of acoustical panels shall not begin until all wet
work (plastering, concrete, etc.) is completed and dry.
Building shall be properly enclosed and under standard
occupancy conditions (temperature of
60-85°F and not more than 70% relative humidity) before
installation begins.
1.6 The contractor shall be responsible for the examination
and acceptance of all surfaces and conditions prior to the
acoustical panel installation.
1.7 Substitutions or changes will only be permitted by prior
approval by the architect.
PART 2 MATERIALS
2.1 Acoustical wall panels shall be: Respond ® IR Series
Acoustical Wall Panels as manufactured by Conwed
Designscape|Wall Technology, 800 Gustafson Road,
Ladysmith, WI 54848. Phone (800) 932-2383,
fax (800) 833-4798
2.2 Acoustical Panels shall be constructed of a composite
core construction of dimensionally stable rigid fiberglass
of 6-7 pcf density laminated to 1/8” 16-20 pcf molded glass
fiber. Thickness (choose one) ½”, ¾”, 1”, 1-½”, 2”, 3”, 4”
plus 1/8” or custom ________(specify).
2.3 Sizes: ______ width and _______ high or as shown on
drawings. Standard maximum size is 4’ x 12’ or 5’ x 10’
(nominal) for 1”, 2” and 3”. 4’ x 10’ is the maximum size
for ½”, ¾” and 1-½”. 4” is limited (by weight) to 24 square
feet; either 4’ x 6’ or 2’ x 12’ or custom. Panels are to be
manufactured according to field dimensions supplied by
the installing contractor.
2.4 Edge profile shall be: Square, radius, full bevel, halfbevel, miter, or custom __________________
(specify). Corner detail shall be: Square, radius or custom
_______________ (specify). Edge treatment shall be:
resin hardened, aluminum or high-pressure laminate (with
square edge only), wood (all profiles available) or custom
____________ (specify).
2.5 Panel finish shall be _________________________
____________ (specify finish manufacturer, pattern,
color and specifier). Finish shall be applied directly over
the face and edges of the panel and returned to the back
of the panel to provide a full finished edge. All corners are
fully tailored.
2.6 Mounting shall be: Adhesive/Resin, Adhesive No Resin,
Impaling/Adhesive, Lay-in, Magnet, Spline, VELCRO ®,
Panel Clip to Z-Bar, Panel Clip to Double Wall Clip,
Z-Bar to Z-Bar, Aluminum Z-Clips, Panel Clips/VELCRO®
or custom ____________ (specify). Adhesive,
miscellaneous fasteners, (i.e. nails, screws, etc.) and
standard continuous wall leveling angle are to be supplied
by the contractor.
2.7 Acoustical Performance – panels shall have a minimum
NRC of _____ (please specify).
2.8 Flammability – All