Field Installation and Service Manual IMS120 | Page 9
SP.4 Carefully place the Wood Top in its opening again with the opposite end down. If the weight of the Wood Top
will damage the wall at the raised end before it is cut to fi t completely, use a block of some sort such as scrap lumber to
relieve the stress on the side wall.
Set the scribe tool to align with this new mark and draw a line across its end that corresponds to the wall.
Finished Top Niche Scribe Process
Top View
Wall to Wall
Niche Dimension
Ensure Front of Top is Parallel to Front Face of Cabinets
Front View
Scribe Tool Set to
Measured Mark on top
at Cabinet Face Depth
Place the Uncut End of the Top Into the
Opposite Cornerof the Opening and
Mark the Wall Condition Onto the
Top with a Scribe
Prevent Damage of the Wall
from the Top by Relieveing
its Weight With a
Temporary Block
120
Remove the Wood Top and scribe cut the end to the new line.
At this point, it should fi t snug to the wall condition from side to side. Confi rm that it is still parallel to the front face of the
cabinets and make any adjustments necessary to correct the fi t.
To complete the fi tting, perform the same process described earlier in this method sheet (Steps 4 and 5) to scribe fi t the
back edge of the Wood Top to the back wall, if needed, and secure it to the cabinets.
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 120
9