Field Installation and Service Manual IMS108 | Page 13

Crown Molding and Sub Crown Splice Placement
Crown Splice centered
over a fascia break no closer than
18” to any end or corner
Crown Splice-
22-1/2 degree
scarf or lap joint
Sub Crown Splice-
45 degree
scarf or lap joint
Sub Crown Splice centered
over a facsia break no closer than
18” to any end or corner
Do not stack the
Sub Crown and
Crown Molding
splices over the
same fascia break
108
Separate the splices
as far as possible
Install the piece that shows
the face of the splice cut first
so the final piece
can overlap the splice
Butt Joint
splices
Crown Corner
45 degree
splices
Each side is cut
flat against the
miter saw fence
at 22-1/2 degrees
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 108
13