Field Installation and Service Manual IMS107 | Page 2

Field Installation and Service Manual
SECTION 1 - INSTALLATION
Installing a
Hood Vent Shroud
Illustrated Method Sheet 107
Step 1
Layout and Cut the Shroud Parts
1.1
Design the
width of the shroud
the same width as
the Hood Cabinet.
Top View
Top of
Hood Cabinet
11-3/4”
Hood
Vent
Shroud
Hood Vent
Shroud
Layout
Bottom
Cleat
10-3/4”
Upper
Corner Cleat
Side Elevation
1-1/8”
Ceiling
Front Elevation
Hood Vent
Cabinet Width
The procedure detailed in
this Illustrated Method
Shee t assumes that the
Wall Cabinets have been
installed correctly, plumb,
level and square.
Shroud
10-3/4”
10-1/8”
1/4”
Short of
Ceiling
Hood
Vent
Back
Wall
Hood Cabinet
Hood Cabinet
11-7/8”
Hood Vent Shrouds are
required when vents
must exit above the
cabinets and they do not
install against the ceiling.
They are completely laid
out, cut, assembled and
installed by the installer
from a single sheet of
material.
1.2
Design the height of the Hood Vent Shroud to fi nish within 1/4” of horizontal
soffi t or ceiling line.
If a typical crown confi guration using Shadow Molding (ATSM) is specifi ed, the sides
of the shroud should be designed at a width of 10-3/4” overall.
This will allow for the Shadow Molding and crown to be installed without interference
from the shroud.
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 107
2